| Water stain on the ceiling right around the chimney, worst after rain | Failed or rusted flashing (most common by far) | Strip and re-flash with new step + counter-flashing into the mortar | Soon — water is already inside the assembly |
| Dampness high up near the chimney top / inside the firebox | Cracked or deteriorated crown | Patch or recast the crown and seal hairline cracks | Moderate — gets worse every freeze-thaw |
| Water, leaves, or animals coming straight down the flue | Missing, rusted, or undersized cap | Install a properly sized stainless cap with mesh | Soon — also a nesting / draft problem |
| Brick faces flaking, popping, or crumbling | Spalling brick from freeze-thaw (water already soaked in) | Replace spalled brick + repoint and waterproof | Moderate — spreads if left wet |
| Crumbly, recessed, or missing mortar between bricks | Failed mortar joints — needs repointing | Grind out and repoint the joints, then seal | Plan ahead — it's the slow root cause |
| Ponding, debris, or a stain trail on the up-slope side of a wide chimney | No cricket / saddle diverting water around it | Build a cricket and tie it into new flashing | Moderate — chronic until diverted |